Machining center regular maintenance project - Solutions - Huaqiang Electronic Network

Brand AVX TPSE226M035R0125 Low impedance tantalum capacitor AVX 22

Electronic scale crystal oscillator 3.2*2.5mm 3225 16M (16.000MHZ) 12PF 10PPM 20PPM 30PPM

Factory direct sales - solid capacitor - patch aluminum electrolysis, to ensure that the factory first-class goods!

Mechanical part 1, check lubrication system, Pressure Gauge status, clean lubrication system filter, change lubricant, clear oil passage,
2. Check the air circuit system and clean the air filter to eliminate leakage of pressure gas.
3. Check the fluid system, clean the filter, clean the tank, and replace or filter the oil. Replace the seal if possible.
4. Tighten the transmission parts and replace the bad standard parts.
5. Grease lubrication parts, add grease according to requirements, clean and clean each transmission surface.
7. Check the status of the tool magazine and robot, analyze the wear status of the robot, and propose replacement suggestions to the customer.
8. Repair the damaged parts of the external components.
9. Check the status of the shield. Accurately feed back information to customers.
Electrical part 10, clean the electrical components in the control cabinet, check and tighten the fastening state of the terminal.
11, cleaning, cleaning CNC system control module, circuit board, cleaning fan, air filter, cleaning heat sink,
12. Clean the servo motor fan blades.
13. Clean the internal components of the operation panel, circuit board and fan. Check the fastening status of the connector.