Waterproof IP68 2200 Lumens Archon LED Dive Flashlight
- Model NO.: WG96
- Power Supply: Rechargeable Battery
- Charging type: Rechargeable
- With Light Source: With Light Source
- IP Rating: IP68
- Surface Preparation of Reflecting cup: Smooth
- Certification: CE, RoHS
- Bulb: Sst-90 LED(Max 2200 Lumens)
- Color Temperature: 6000 K
- Lens: 8mm Polycarbonate Board
- Angle of Light Beam: 8° Hot Spot, 110° Periphery
- Dimensions: 213.5mm (Length)* 78.0mm (Dia. of Head)
- Transport Package: EVA Gift Packing.
- Origin: Shenzhen of Guangdong
- Usage: Underwater 100 Meters Diving Flashlight
- Switch: Back Push (on/off)
- Runtime: >6H
- Battery Type: Lithium Battery
- Material of Reflecting cup: Metallic
- Material: Aluminum Alloy
- Model Item: Wg96
- Operation Voltage: 9V to 13V
- Reflector: Glossy Aluminum Reflector
- Body Material: Durable Aircraft-Grade Aluminum
- Battery: Rechargeable Li- Ion Battery Pack (18650 Battery*6
- Trademark: ARCHON
- Specification: CE, RoHS
- HS Code: 85131010
Â
Model | Archon New Model WG96 Flashlight Rechargeable |
 Bulb | SST-90 LED *1 (max 2200 Lumens) |
 Color temperature |  6500 K (white light) |
 Reflector |  8° hot spot,110° periphery |
 Lens |  8mm Polycarbonate Board; |
 Battery |  18650 rechargeable Li- ion battery *6; |
 Battery Indicator |  100%-50%: Green; 50%-30%: Yellow; 30%-10%:     Red; Below 10%: Red Flashing; Below 5%: switch off; |
 Protection | Polarity reversing protection. Gas release valve |
BATTERY CHARGING
1. Plug the charger in the wall power socket, the indicator light is green
In the free-load status.
2. Plug the port of the charger in the ports on the light. (the positive and
Negative polar doesn't matter, both ways work. )
3. The indicator light on the charger is red if the battery is not fully
Charged; It will turn green after fully charged.
4. Take out the charger and use the light.
ON/OFF
Push the switch to turn it ON.
MODES CHANGING
Successive push the switch ON-OFF within two seconds to cycle through High, Low, strobe, OFF.
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.
Power Distribution,Medium Voltage Switchgear,Voltage Switchgear
Vacuum Circuit Breaker Co., Ltd. , http://www.nstransformer.com